Worktop templating in Canonbury

Yes. Canonbury is on the patch, and the postcodes we work here are N1. It is run from the Watford side, covering Hertfordshire & North London. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The party wall is the straightest surface in the house and everything else has moved away from it over a century. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Recorded as it is, not as it was drawn. Rear extensions here are frequently new build butted against old brick, so allow a movement gap at the junction rather than running one uninterrupted top across the old and new wall line.

Traffic filters close several through routes and the CPZ is permit-heavy, so the van often stops a street away from the address. Long front gardens and railed steps make for a ten to twenty metre carry before the door, then a straight hall to the rear. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.