Worktop templating in Canada Water

Yes. Canada Water is on the patch, and the postcodes we work here are SE16. It is run from the New Malden side, covering South West London & Surrey. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A gated development controls when a van gets in, where it can stand and for how long, and none of that gets decided on the morning. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Recorded as it is, not as it was drawn. The whole job is dictated by the service lift booking - one slot, one lift, so the tops get cut into liftable pieces and jointed on site.

Everything goes through a concierge and a booked service lift with a delivery slot, loading bays are timed, and the goods route runs through basement car parks with 2m headroom that a long-wheelbase van clears but a roof-racked slab frame does not. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.