Worktop fabrication in Charlton

Yes. Charlton is on the patch, and the postcodes we work here are SE7. It is worked on our south east London run, along with the rest of Greenwich. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The party wall is the straightest surface in the house and everything else has moved away from it over a century. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Every join over a gable, clear of every cut-out. Some of the steepest carries in the borough are here, if the van can't get above the house, budget for pushing a slab up a 1-in-8 pavement.

The roads climb hard from the riverside up to the village and parking on the terraced streets is nose-to-tail; the interwar semis higher up usually have a drive, which changes the job completely. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.