Worktop templating in Charlton

Yes. Charlton is on the patch, and the postcodes we work here are SE7. It is worked on our south east London run, along with the rest of Greenwich. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A semi has a side passage, and whether it is wide enough to carry a piece flat and turn it in at the back door is the first thing worth measuring. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Two to three hours, once the units are in. Some of the steepest carries in the borough are here, if the van can't get above the house, budget for pushing a slab up a 1-in-8 pavement.

The roads climb hard from the riverside up to the village and parking on the terraced streets is nose-to-tail; the interwar semis higher up usually have a drive, which changes the job completely. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.