Worktop templating in Dagenham

Yes. Dagenham is on the patch, and the postcodes we work here are RM9, RM10. It is run from the Essex side, covering Essex & East London. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. No stone is ever cut from a plan. Most Dagenham jobs are about maximising continuous run length in a small room, so we plan the sink and hob positions to leave one usable stretch of at least 900mm.

Generally good — wide estate roads, front gardens, hardstanding and free parking on most streets, though the flat blocks bring the usual lift and landing constraints. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.