Kitchen worktops in Longthornton

Yes. Interwar semis on the Streatham fringe with rear kitchens that get modest three or four metre extensions rather than full-width rears, keeping an L-shaped run and a small dining area. Original serving hatches and pantry recesses are usually absorbed into the new layout. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

1930s semi, Interwar terrace and Postwar infill flat. There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the whole opening has to be shot across from one datum. Recorded as it is, not as it was drawn.

Parking is unrestricted on most roads and driveways are common, though the streets are narrower here than in the Morden suburbs and get tight when both sides are parked. Side gates are the usual squeeze at around 750mm. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Worktop installation, worktop replacement and worktop templating, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. Extensions of this vintage often meet the original wall with a stepped floor level, so check whether the run crosses that threshold before assuming one continuous height.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.