Kitchen worktops in Streatham Common

Yes. Bigger houses on the slopes above the common support proper family kitchens with a 4m run, a 2.5m island and a utility off the back, often with a range cooker needing a full-height stone splashback. Ceiling heights allow tall wall units, so the panel behind the hob is a substantial piece in its own right. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

Large Edwardian semi, Victorian villa, 1930s detached and Interwar block. Half-landings mean the back of the house sits at a slightly different level from the front, and a knocked-through kitchen crosses that line. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. Priced from the building, not from a rate card.

Roads rise steeply away from the common with stepped front gardens and long paths, so the carry involves several steps up before the front door. Parking is easier than on the high road but the gradient makes trolley work risky when wet. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

Worktop design & quotation, worktop splashbacks & upstands and worktop installation, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Full-height splashback panels behind a range need the flue and bracket positions confirmed first, because a 900mm tall panel with a badly placed cutout cannot be salvaged.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.