Worktop installation in Morden Park

Yes. Morden Park is on the patch, and the postcodes we work here are SM4. It is worked on our south west London run, along with the rest of Merton. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. The day is planned backwards from the hall. That is the shape of the day. Infill extensions are frequently narrower than a standard worktop plus walkway, so confirm the finished internal width before ordering, 600mm depth plus an island is not always possible.

Off-street parking is normal and roads are wide, so the van gets to the door. The pinch point is the side passage into an infill extension, which is often built out to within 700mm of the boundary fence. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The fitting day is planned backwards from that point, before anything comes off the van. None of it is worked out on the doorstep.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop replacement. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day.