Worktop fabrication in Morden Park

Yes. Morden Park is on the patch, and the postcodes we work here are SM4. It is worked on our south west London run, along with the rest of Merton. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Every join over a gable, clear of every cut-out. Infill extensions are frequently narrower than a standard worktop plus walkway, so confirm the finished internal width before ordering, 600mm depth plus an island is not always possible.

Off-street parking is normal and roads are wide, so the van gets to the door. The pinch point is the side passage into an infill extension, which is often built out to within 700mm of the boundary fence. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop templating and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.