Worktop design and quotation in New Southgate

Yes. New Southgate is on the patch, and the postcodes we work here are N11. It is worked on our north London run, along with the rest of Barnet. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. It sits in the fitting line as time on site rather than as anything to do with the stone. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. The second thing is the carry route: front door, narrow hall, a turn at the stairs and often a step down into the extension, which can mean a piece that would template in one length has to be split to physically get into the room. Priced from the building, not from a rate card. Developer kitchens use 600mm carcasses with a chipboard top glued down, so allow time to break out the old top cleanly without damaging the units the customer wants to keep.

Industrial and railway land breaks the road pattern up, so routes are indirect; new blocks have loading bays and lifts, while the older terraces have no drives and tight permit parking near the station. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.