Worktop fabrication in New Southgate

Yes. New Southgate is on the patch, and the postcodes we work here are N11. It is worked on our north London run, along with the rest of Barnet. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. Pieces are sized to the tightest turn on the route before anything is nested to the slab. The bench proves it before the van moves. Developer kitchens use 600mm carcasses with a chipboard top glued down, so allow time to break out the old top cleanly without damaging the units the customer wants to keep.

Industrial and railway land breaks the road pattern up, so routes are indirect; new blocks have loading bays and lifts, while the older terraces have no drives and tight permit parking near the station. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.