Worktop installation in New Southgate

Yes. New Southgate is on the patch, and the postcodes we work here are N11. It is worked on our north London run, along with the rest of Barnet. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cottage terraces have no hall to speak of and the front door opens almost straight into the room, which makes the carry easier and the protection harder. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day. Developer kitchens use 600mm carcasses with a chipboard top glued down, so allow time to break out the old top cleanly without damaging the units the customer wants to keep.

Industrial and railway land breaks the road pattern up, so routes are indirect; new blocks have loading bays and lifts, while the older terraces have no drives and tight permit parking near the station. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. We walk the route with a tape and protect it end to end before the first piece is lifted. That is what the morning is planned around.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The back edge is eased in progressively rather than offered up once and forced. Eased in, never forced. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.