Worktop fabrication in Park Royal

Yes. Park Royal is on the patch, and the postcodes we work here are NW10, W3. It is worked on our north west London run, along with the rest of Brent. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original brickwork is uneven by ten millimetres or more across a bay, so the back edge is scribed to the actual face rather than to a line. Access is by goods lift or a shared stair with a hard turn onto the landing, and both cap the piece length, so the nesting is done to the measured car or turn rather than to the slab. Settled on the drawing, cut once. This is the collection end of the job rather than the fitting end, and a slab picked up here still has to survive the North Circular before it reaches a kitchen.

Wide industrial roads, forklift-friendly yards and A-road access, which is exactly why the supply chain sits here. Domestic drops at the edges are ordinary kerbside jobs, but weekday HGV traffic around the estate makes timing slots unreliable. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The island layout, including whether the ends are mitred down to the floor, needs settling before cutting, since mitred ends are cut in sequence with the top and dry-assembled as one unit. Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.