Worktop fabrication in Pimlico

Yes. Pimlico is on the patch, and the postcodes we work here are SW1V. It is worked on our central London run, along with the rest of Westminster. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. The bench proves it before the van moves. Post-war estate kitchens use non-standard cabinet depths and out-of-square corners from the original concrete frame - template every corner, do not assume 90 degrees.

Estate blocks are the constraint - low-rise sections with no lift at all, walkway access, and communal doors that must not be wedged. Street parking is permit and pay-by-phone with a lot of resident pressure, and the wider stucco streets have suspended bays for other trades most weeks. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.