Worktop replacement in Pimlico

Yes. Pimlico is on the patch, and the postcodes we work here are SW1V. It is worked on our central London run, along with the rest of Westminster. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. What is under the old top is the real question. Post-war estate kitchens use non-standard cabinet depths and out-of-square corners from the original concrete frame - template every corner, do not assume 90 degrees.

Estate blocks are the constraint - low-rise sections with no lift at all, walkway access, and communal doors that must not be wedged. Street parking is permit and pay-by-phone with a lot of resident pressure, and the wider stucco streets have suspended bays for other trades most weeks. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. It sets what the day actually looks like.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. It is the usual surprise, and it is a known one. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.