Worktop design and quotation in Plumstead

Yes. Plumstead is on the patch, and the postcodes we work here are SE18. It is worked on our south east London run, along with the rest of Greenwich. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. The quote separates the joins the run needs from the joins the route forces, because they are different decisions with the same price. That is what the itemised lines are for. Old lath-and-plaster and soft brick mean scribing to bowed walls is normal; assume the back wall is out by 15mm over 3m.

Steep hillside streets with permit parking and no driveways, plus long flights of front steps on the upper roads, the carry is usually uphill and through the house rather than round the side. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.