Worktop fabrication in Plumstead

Yes. Plumstead is on the patch, and the postcodes we work here are SE18. It is worked on our south east London run, along with the rest of Greenwich. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Old lath-and-plaster and soft brick mean scribing to bowed walls is normal; assume the back wall is out by 15mm over 3m.

Steep hillside streets with permit parking and no driveways, plus long flights of front steps on the upper roads, the carry is usually uphill and through the house rather than round the side. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.