Kitchen worktops in Ravenscourt Park

Yes. Big terraces around the park take double side-return extensions with kitchen islands of 3m and a separate utility, and a lot of them go for full-height stone splashbacks behind a range because the rear wall is glazed and the cooking wall is the only solid one. The villa conversions are the counterpoint - first-floor flats with a galley of 2.4-3m squeezed into a former bedroom and a joist run that will not take much extra load. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it.

large Victorian terrace and semi, Edwardian villa, purpose-built interwar flats and conversion flat in a former villa. These kitchens are big rooms with long perimeter runs and an island, so level has to hold across the whole floor rather than along one wall. These are the multi-piece jobs: long runs, a large island and often a range cooker that cannot be moved, so the stone is templated in several pieces and how the vein runs across the joins matters. Units kept, surface changed, one day.

Streets are wide with plane trees and permit bays, but the District line viaduct and the park perimeter cut through the grid so approach routes are longer than the map suggests. Conversion flats have a shared front door, a straight run of stairs and a landing that is often under 1m wide, which is the practical piece-length ceiling. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop templating, worktop fabrication and worktop replacement, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. In first-floor conversions check the joists before you fit 30mm granite on a long island - old timber floors here flex enough to open a joint.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.