Worktop templating in Ravenscourt Park

Yes. Ravenscourt Park is on the patch, and the postcodes we work here are W6. It is worked on our west London run, along with the rest of Hammersmith and Fulham. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original walls are thick, lime-plastered and rarely straight, which makes dry-laying and scribing the bulk of the fitting day. Long perimeter runs and an island mean level has to hold across the whole room, so the templater sets a single datum and works every run and the island off it rather than levelling each wall in isolation. Two to three hours, once the units are in. In first-floor conversions check the joists before you fit 30mm granite on a long island - old timber floors here flex enough to open a joint.

Streets are wide with plane trees and permit bays, but the District line viaduct and the park perimeter cut through the grid so approach routes are longer than the map suggests. Conversion flats have a shared front door, a straight run of stairs and a landing that is often under 1m wide, which is the practical piece-length ceiling. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop replacement. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.