Worktop fabrication in Ravenscourt Park

Yes. Ravenscourt Park is on the patch, and the postcodes we work here are W6. It is worked on our west London run, along with the rest of Hammersmith and Fulham. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. The joins here are chosen rather than forced, so they go where the veining and the gables want them. Every join over a gable, clear of every cut-out. In first-floor conversions check the joists before you fit 30mm granite on a long island - old timber floors here flex enough to open a joint.

Streets are wide with plane trees and permit bays, but the District line viaduct and the park perimeter cut through the grid so approach routes are longer than the map suggests. Conversion flats have a shared front door, a straight run of stairs and a landing that is often under 1m wide, which is the practical piece-length ceiling. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.