Splashbacks and upstands in Thamesmead

Yes. Thamesmead is on the patch, and the postcodes we work here are SE28, SE2. It is worked on our south east London run, along with the rest of Greenwich. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense block or in-situ concrete with a bonded plaster, so the bottom course of tiles brings plaster with it when the old top comes off. The rear kitchen wall in ex-council flats and maisonettes is commonly dense in-situ concrete or blockwork with a thin skim, which means mechanical fixings are hard work and the splashback is held on adhesive rather than screwed. Cut from the same slab run as the tops. Fixing into precast concrete needs the right anchors and serious dust control, nothing here takes a plasterboard fixing.

Raised pedestrian decks, podium levels and garage undercrofts mean the front door is often nowhere near where the van can park, and some blocks are reached only by a walkway or a small lift. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. That is agreed at template, not on fitting day.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A lightweight stud partition will not carry a breakfast bar or a peninsula end, and stone finds that out faster than laminate ever did. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops.