Worktop fabrication in Thamesmead

Yes. Thamesmead is on the patch, and the postcodes we work here are SE28, SE2. It is worked on our south east London run, along with the rest of Greenwich. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. Every join over a gable, clear of every cut-out. Fixing into precast concrete needs the right anchors and serious dust control, nothing here takes a plasterboard fixing.

Raised pedestrian decks, podium levels and garage undercrofts mean the front door is often nowhere near where the van can park, and some blocks are reached only by a walkway or a small lift. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Changes cost a piece, not a tweak.