Worktop fabrication in Woolwich Dockyard

Yes. Woolwich Dockyard is on the patch, and the postcodes we work here are SE18. It is worked on our south east London run, along with the rest of Greenwich. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. Pieces are sized to the tightest turn on the route before anything is nested to the slab. Every join over a gable, clear of every cut-out. Expect to work around a wall-hung combi and a back door, usable run is often a metre shorter than the room suggests.

Narrow streets running down toward the river with parking on both sides and a couple of routes severed by the rail line; short carries, but rarely anywhere legal to stop for long. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.