Worktop fabrication in Downham

Yes. Downham is on the patch, and the postcodes we work here are BR1, SE6. It is worked on our south east London run, along with the rest of Lewisham. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An inter-war terrace is wider than a Victorian one and shallower than a semi, so the kitchen is a compact square room rather than a galley. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Settled on the drawing, cut once. The same 3.2m L comes up constantly here, but check for the original chimney breast, it's often still there behind the plaster.

Very easy: wide roads, grass verges, dropped kerbs and driveways or hardstandings on most properties, with room to park a long van directly outside. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Machined to the real line. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.