Worktop installation in Dulwich Village

Yes. Dulwich Village is on the patch, and the postcodes we work here are SE21. It is worked on our south east London run, along with the rest of Southwark. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. Rear or shared-path access is often the only way to bring a long piece in without turning it in the hall. The slow parts are slow for a reason. Clients here specify large-format slabs and book-matched islands, so slab selection and vein layout are part of the job rather than an afterthought.

The Dulwich Estate scheme of management governs external alterations, so extensions and rooflights are consented and often set back; the roads are wide with driveways and off-street standing, which makes this some of the easiest unloading in the borough. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. The back edge is eased in progressively rather than offered up once and forced. Eased in, never forced. Unlock any rear or shared path gate and clear both the hall and the back approach so we can choose the better route on the day. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Protection goes down first.