Worktop templating in Harmondsworth

Yes. Harmondsworth is on the patch, and the postcodes we work here are UB7. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. No stone is ever cut from a plan. Solid brick cottage walls are nowhere near plumb, so scribing a 900mm return can take longer than cutting the whole run did.

Village lanes are narrow with parking on both sides and nowhere to turn a Luton. The way in is off the Bath Road or the M4 spur and you reverse out the way you came. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop fabrication. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.