Worktop templating in Longford

Yes. Longford is on the patch, and the postcodes we work here are UB7. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. No stone is ever cut from a plan. Low ceilings and beams mean you cannot upend a slab once you are inside, so it comes in flat and gets set in one movement.

Frontages sit directly on the Bath Road opposite the airport perimeter fence, with heavy commercial traffic passing and effectively no residential parking. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop fabrication. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A deep scribe comes out of the nest, so how far the stone has to be relieved changes which part of the slab the piece is cut from. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Appliances on site, not on order.