Worktop design and quotation in Royal Albert Wharf

Yes. Royal Albert Wharf is on the patch, and the postcodes we work here are E16. It is worked on our east London run, along with the rest of Newham. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A riverside block is a managed building with a booked goods lift, a loading bay and a concierge, and all three have to line up on the same day. Runs are short enough that a small U or galley often comes out of one slab with good yield, which means the material band you pick (£110-£550/m² supply only) is doing most of the work in the total, not the shape of the room. Priced from the building, not from a rate card. Shared lifts across multiple cores make this a slow building to work in, so allow a longer window than the fit itself needs.

The development sits at the end of a long approach past the dock with limited through-traffic, so allow travel time but expect a clear road at the end of it. Service access is through a courtyard with bollards and a small number of shared lifts serving several cores, which means a booking and often a wait. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send a floor plan with the run lengths and confirm whether the existing units and sink are staying, along with the goods lift or loading bay rules if the building has any. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.