Worktop templating in Royal Albert Wharf

Yes. Royal Albert Wharf is on the patch, and the postcodes we work here are E16. It is worked on our east London run, along with the rest of Newham. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Floor-to-ceiling glazing lights the worktop from one side all day, which shows every ripple in a polished surface and every gap at a scribe. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Recorded as it is, not as it was drawn. Shared lifts across multiple cores make this a slow building to work in, so allow a longer window than the fit itself needs.

The development sits at the end of a long approach past the dock with limited through-traffic, so allow travel time but expect a clear road at the end of it. Service access is through a courtyard with bollards and a small number of shared lifts serving several cores, which means a booking and often a wait. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.