Worktop templating in Gallions Reach

Yes. Gallions Reach is on the patch, and the postcodes we work here are E6, E16. It is worked on our east London run, along with the rest of Newham. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Timber-frame construction with plasterboard linings means every fixing has to find a stud, and a peninsula end needs proper support built in beforehand. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. Two to three hours, once the units are in. Modern square rooms make this the closest thing to a drawing-office job in the borough, though the island's overhang still needs proper brackets, not just adhesive.

Wide modern roads, retail park loading and driveways on most houses mean a full-size van can park at the door with no permit issues. Newer blocks have modern lifts of a usable size, but gated parking courts need a resident to let the van in. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A lightweight stud partition will not carry a breakfast bar or a peninsula end, and stone finds that out faster than laminate ever did. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.