Worktop templating in Aldborough Hatch

Yes. Aldborough Hatch is on the patch, and the postcodes we work here are IG2. It is run from the Essex side, covering Essex & East London. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. The scribe at worktop height differs from the one at plinth level, and only the worktop line matters. No stone is ever cut from a plan. The older properties out here have uneven floors, so levelling the base units properly matters more than usual before any stone goes down.

Semi-rural feel with verges, unrestricted parking and generous frontages, so unloading is easy; the older cottages have low door heads and narrow openings that dictate how a slab is carried in. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.