Worktop templating in Cockfosters

Yes. Cockfosters is on the patch, and the postcodes we work here are EN4. It is run from the Watford side, covering Hertfordshire & North London. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the laser has to be shot across the whole opening from one datum. No stone is ever cut from a plan. Where the kitchen opens into a garden room, the run often ends at a glazed corner with no wall to scribe against, so the exposed end needs a fully polished, matched edge.

Very wide roads with verges, long driveways and space to work off the plot; side access is usually clear because plots are wide. Station-side flat blocks have gated parking and small lifts. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.