Worktop templating in Hacton

Yes. Hacton is on the patch, and the postcodes we work here are RM12. It is worked on our east London run, along with the rest of Havering. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Bungalow kitchens are frequently extended into the rear or opened into the roof space, so the room is part original and part new build. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. Recorded as it is, not as it was drawn. Bungalow kitchens here run short of wall because of the window positions, so we plan the run around the glazing rather than trying to force a standard layout.

Wide verged roads with drives and garages, easy standing for the van, and level ground floors in the bungalows which makes the carry simple. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.