Worktop templating in Kenton

Yes. Kenton is on the patch, and the postcodes we work here are HA3, HA9. It is worked on our north west London run, along with the rest of Harrow. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Houses of this period came with generous garages and utility rooms, so a second short run of stone is often part of the same job. The sill height over the sink is settled on site, because there is often less clearance than an upstand is tall. Recorded as it is, not as it was drawn. Runs over 4m mean planning the joint around the hob and the sink so the seam falls where it will not sit in standing water.

Wide straight roads, drives on most houses and reliable side access down 900mm alleys, so slabs commonly go straight to the rear. Kenton Road itself is a busy through route where kerbside stopping is awkward at peak times. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extended households run kitchens hard, and that pushes the specification towards granite or sintered stone rather than a light quartz. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.