Kitchen worktops in Leytonstone

Yes. The larger Victorian and Edwardian houses take a full-width rear extension with a 4m run and a 2m island, and the plainer terraces run a 2.6m galley in the back addition. Islands here often carry the sink because the rear wall is mostly glazing. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window.

Victorian villa, Edwardian terrace, 1930s semi and small recent apartment block. The rear extension is frequently original rather than added, which means it is solidly built and just as far out of square as the rest of the house. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn.

The High Road is a red route in sections with bus lanes, and the residential grid has modal filters that force approach from one particular end. Front gardens are shallow, hallways are narrow with a stair turn, and few houses have usable side access, so island slabs come in through the house. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Worktop design & quotation, worktop templating and worktop installation, in that order. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. Sink-in-island layouts are common here, which means plumbing routes and support for the cut-out need agreeing with the kitchen fitter before templating.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Rushing that is what leaves a gap you look at every morning for fifteen years. Eased in, never forced. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.