Worktop design and quotation in New Addington

Yes. New Addington is on the patch, and the postcodes we work here are CR0. It is run from the New Malden side, covering South West London & Surrey. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Base units from the seventies and eighties are often only 500mm deep, so a 600mm stone top overhangs at the front and the doors want checking against it. With little area to spread them over, the cut-outs and the fixed lines carry the quote, so each is listed on its own. You see it before you commit to anything. Because the house types repeat across the whole estate, once you have templated one kitchen you know the run length on the next, but you still template every one because previous owners have moved the back door.

Wide estate roads, grass verges you must not drive on, and long shared paths serving several front doors. Maisonettes have external stairs with a handrail that limits how you can swing a piece. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Nothing payable until template.