Worktop templating in St Paul's

Yes. St Paul's is on the patch, and the postcodes we work here are EC4M. It is run from the Essex side, covering Essex & East London. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Dot-and-dab plasterboard bellies at a taped internal angle, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. New-build rooms are genuinely square, but they are dot-and-dab plasterboard, and the taped internal angle is where it goes wrong - the board bellies at the corner and the run picks up a few millimetres over the last 300mm. Recorded as it is, not as it was drawn. Stepped and setted paving around the cathedral will jar a trolley badly, so carry the last stretch on a frame rather than wheeling it over the flags.

The immediate cathedral surroundings are pedestrianised with bollards and stepped paving, so the van stops on a permitted street and the last 100m or more is on foot across paving that is unkind to a trolley. Service access to residential floors is usually shared with the commercial tenants and restricted to outside their delivery hours. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.