Worktop design and quotation in Blackheath Standard

Yes. Blackheath Standard is on the patch, and the postcodes we work here are SE3, SE7. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. With little square metreage to spread them over, the cut-outs and the fixed template, fabrication and fitting lines carry the quote, so each one is listed separately rather than buried in a rate. You see it before you commit to anything. On the Span houses keep to slim profiles and modest overhangs — the original joinery and window lines are tight and a chunky mitred edge reads wrong immediately.

The Span courtyards are car-free with communal parking set back from the houses, so it is a barrow or carry across paving; the Victorian streets have permit bays and nothing else. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. That is why the fitting line on a quote reflects manpower and time rather than square metres. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.