Worktop templating in Blackheath Standard

Yes. Blackheath Standard is on the patch, and the postcodes we work here are SE3, SE7. It is run from the New Malden side, covering South West London & Surrey. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. Runs commonly finish at a doorway, and the architrave and skirting stand proud of the plaster, so the end of the top is notched or stopped on the drawing. No stone is ever cut from a plan. On the Span houses keep to slim profiles and modest overhangs — the original joinery and window lines are tight and a chunky mitred edge reads wrong immediately.

The Span courtyards are car-free with communal parking set back from the houses, so it is a barrow or carry across paving; the Victorian streets have permit bays and nothing else. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.