Worktop installation in Feltham

Yes. Feltham is on the patch, and the postcodes we work here are TW13, TW14. It is worked on our west London run, along with the rest of Hounslow. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original quarry-tiled floors sit lower than a later screed, so a run crossing that junction needs the units packed to one level. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day. High volume of straight swap-outs where the old laminate was hiding a badly out-of-level base run, so packing the units is genuinely half the install time.

Easy. Off-street parking on most streets, very little controlled parking, and the A312 and A314 feed the area directly. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The fitting day is arranged with whoever can actually give us access for the whole slot. One visit, our own installers.