Worktop fabrication in Fullwell Cross

Yes. Fullwell Cross is on the patch, and the postcodes we work here are IG6. It is worked on our east London run, along with the rest of Redbridge. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The internal stair is usually a straight flight with a tight top landing, and it is the landing rather than the flight that is the limit. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. The bench proves it before the van moves. For anything above ground floor here we measure the stair turn first, a 3m piece will not make the bend, so we plan a joint rather than find out on delivery day.

Residential roads are fine and most houses have a drive, but the maisonettes above and behind the parade mean a straight-flight staircase carry with a half-landing turn that limits what length we can get up in one piece. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. The drawing decides it, not the fitter. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.