Worktop installation in Hacton

Yes. Hacton is on the patch, and the postcodes we work here are RM12. It is worked on our east London run, along with the rest of Havering. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the roof has been converted there is usually a steel over the kitchen that went in after the walls, and the run beneath it is worth checking for square. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day. Bungalow kitchens here run short of wall because of the window positions, so we plan the run around the glazing rather than trying to force a standard layout.

Wide verged roads with drives and garages, easy standing for the van, and level ground floors in the bungalows which makes the carry simple. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. We walk the route with a tape and protect it end to end before the first piece is lifted. None of it is worked out on the doorstep.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop replacement. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly.

With three walls in play the chance of one of them being out of square is high, and the template has to carry all three angles. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. Rushing that is what leaves a gap you look at every morning for fifteen years. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Floors and units are protected before anything comes through the door, communal or otherwise. One visit, our own installers.