Worktop templating in Hanwell

Yes. Hanwell is on the patch, and the postcodes we work here are W7. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the laser picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. No stone is ever cut from a plan. A lot of these terraces still have the original outside WC standing in the rear return, so the top has to stop and restart around it rather than run through.

The Uxbridge Road and the approaches to the viaduct congest badly, terraces have no driveways, and the streets near the station are permit-controlled. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

A galley run down a side-return extension usually measures longer than a slab will give in one length, so a join is designed in from the start rather than discovered. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.