Worktop templating in Herne Hill

Yes. Herne Hill is on the patch, and the postcodes we work here are SE24. It is run from the New Malden side, covering South West London & Surrey. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Handmade brick and lime plaster move visibly along a run, and a straight-cut back edge shows it immediately. Long perimeter runs and an island mean level has to hold across the whole room, so the templater sets a single datum and works every run and the island off it rather than levelling each wall in isolation. Two to three hours, once the units are in. These are big rooms with big islands, so the carry through the hall and out to the rear is the deciding factor — measure the narrowest point on that route before agreeing a single-piece island.

The streets have front gardens and gate posts that narrow the approach, and permit parking is enforced. The area floods for events at the park and the railway bridge by the station is a bottleneck for anything arriving from the north. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.