Worktop design and quotation in Mortlake

Yes. Mortlake is on the patch, and the postcodes we work here are SW14. It is run from the New Malden side, covering South West London & Surrey. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Half-landings mean the back of the house sits at a slightly different level from the front, and a knocked-through kitchen crosses that line. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length — anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. New-build kitchens on the redevelopment come with thin composite tops that clients upgrade early, so it is usually a swap onto existing carcasses with the sink and tap reused.

The level crossing on the main road stops traffic repeatedly and the riverside streets are narrow with parking both sides; the new development has controlled access, allocated bays and lifts with booking sheets. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.