Worktop design and quotation in Mottingham

Yes. Mottingham is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Bromley. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense block or in-situ concrete with a bonded plaster, so the bottom course of tiles brings plaster with it when the old top comes off. The fixed lines do not shrink with the room, so on a small kitchen they are a larger share of the total than the stone. You see it before you commit to anything. Galley runs this narrow leave under 900mm between opposing worktops, so we bring the pieces in on edge and set the second run before fitting the sink.

Wide estate roads with plenty of parking and short front paths, so the carry is short and flat, though many houses only have a pedestrian gate and no drive. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.