Worktop design and quotation in Southborough

Yes. Southborough is on the patch, and the postcodes we work here are KT6. It is run from the New Malden side, covering South West London & Surrey. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. Big islands are what drive the number. That is what the itemised lines are for. Raised ground floors mean four or five front steps on most jobs, so the lift plan and step protection matter more than the drive length.

Wide roads with in-and-out driveways and space to park the van clear of the highway, though several houses sit behind a long gravel approach and steps up to a raised ground floor. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop installation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Photographs are worth more than a plan here. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.