Worktop design and quotation in Sydenham Hill

Yes. Sydenham Hill is on the patch, and the postcodes we work here are SE26. It is worked on our south east London run, along with the rest of Lewisham. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Arts and Crafts houses have deep eaves, low windows and inglenook recesses, so the kitchen has more corners and reveals than its floor area suggests. If the island top is a few hundred millimetres longer than the usable length of a slab, you buy a second slab to gain that overhang, the whole slab, not the part you use, and that is a material decision worth more than any other line on the quote. That is what the itemised lines are for. The big-island jobs come from up here and they need a proper lift plan, a 3.2m waterfall piece over gravel is not a two-man carry.

Long private drives, steep approaches off the hill road, gravel and gated entrances, and houses sitting well above or below their gate at the end of a stepped path. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.