Worktop fabrication in Tokyngton and Brent Park

Yes. Tokyngton and Brent Park is on the patch, and the postcodes we work here are HA9, NW10. It is worked on our north west London run, along with the rest of Brent. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. The notch around a boxed stack is machined with a radius, because a square internal corner there is where a top fails. Settled on the drawing, cut once. Budget-led area, so most jobs are like-for-like replacement in a keep-the-units kitchen and the money question is always whether the existing carcasses will take the weight without extra noggins.

Wide-ish estate roads with parking on both sides and a fair number of ground-floor flats reached across a shared forecourt, so a barrow across paving is the normal approach rather than a long hall carry. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.