Worktop templating in Wimbledon Village

Yes. Wimbledon Village is on the patch, and the postcodes we work here are SW19. It is run from the New Malden side, covering South West London & Surrey. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rooms are formally proportioned with deep reveals and shutter boxes, so runs under windows are templated to what is actually there. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. Recorded as it is, not as it was drawn. This is book-matching and mitred waterfall work — vein direction has to be agreed on the actual slab before cutting, because a mismatched island end is the one thing that gets rejected here.

The High Street has loading bans through much of the day and there is effectively no on-street parking on the roads facing the Common. Many houses sit behind gravel drives with a wide but soft approach, and side gates are frequently too narrow for a slab, so the carry goes through the front door and down a hallway with a return. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.